Great Plains Hydraulic Depth Stop - Manual (Page 2)

2
Assembly Instructions
2N-24 & 2N-30 Drills Hydraulic Depth Stop Update 196-188M 10/19/07
Great Plains Mfg., Inc.
end of the left hand gauge wheel cylinder through the mount and
attach it to the elbow (#6). Slip the clevis assembly (#8) over the
cylinder rod clevis and retain it in place with the 3/8" x 3 3/4" long
bolt (#9), 3/8" lock washer and 3/8" nut. Install and re-pin the
base end of this cylinder assembly back onto the main frame with
the valve side of the cylinder toward the drill boxes. The rod end
is to be repined through both the clevis assembly and the clevis.
Reattach the hard line (#10) between the fittings on the base end
of the lift cylinders. Apply the depth stop decal (#11) to the side of
the main frame tube where shown. Depth Stop Assembly
Refer to Figure 2:
Torque the cylinder rod bolts to their proper settings. Install the
valve mount assembly (#1) over the cylinder body on the port
side. The plastic knob (#2) on the assembly must be installed in
the direction of the cylinder base. The assembly is held in place
with four 3/8" x 5 3/4" bolts (#3), 3/8" lock washers and 3/8" nuts,
locating it at the specified distance from the head cap (1 1/2"). In-
stall the tee (#4) into the base end of the cylinder. Loop the 30"
hose (#5) which is attached to the valve assembly and install it
onto the tee (#4) at the cylinder base. Install the 3/4" o-ring x 3/
4" male jic elbow (#6) into the rod end port with the jic end point-
ing toward the base end. Insert the long hose (#7),from the base
Depth Stop Assembly
Figure 2
15663