Great Plains Auto Reset Bolt Retainer - Manual (Page 2)

598-026M 11/29/2004
Great Plains Mfg., Inc.
Auto Reset Bolt Retainer 2
Refer to Figure 2
5. Clean and oil the threads on the 1" x 14" bolts.
6. Place the reset spring lock base (1) on the
bolts which were removed in step four on
page one. Reinsert the bolts in the springs
and tighten until the hole in the spring channel
aligns with the hole in shank pivot arm. Screw
the bolt heads just enough more so the flats
on the side of each bolt head are aligned
straight up and down.
7. Replace the 5/8" x 8" bolt and lock nut re-
moved in step three on page one and remove
the block holding the springs.
Refer to Figure 3
8. Assemble the spring lock clamp (1) together
with 5/16" x 2 1/4" bolts and 1/4" lock nuts.
Just finger tighten the nuts for now.
9. Place the spring lock clamp (1) over the head
of the bolt heads trapping the flats of the bolt.
The tabs (2) on the spring lock base (3) must
stick into the corresponding holes in the lock
clamps (1)
10. Tighten the 5/16" bolts on the spring lock
clamp (1) securely trapping the flats on the
bolt heads.
Figure 2
Install Lock Base
22809
Figure 3
Install Lock Clamp
22810