Great Plains Hyd Hose Route - Manual (Page 2)

196-416M 11/29/
Great Plains Mfg., Inc.
Hyd. Hose Route Update 2
Refer to Figure 2
4. Remove the two 3/4" bolts from the outside of
the pivot pin support cap weldment.
5. Attach one of the wing hose guides to the
wing frame using the two 3/4" bolts removed
in the previous step.
6. Attach the slotted end to the frame using two
1/4" x 1 1/2" bolts, 1/4" flat washers and 1/4"
lock nuts.
NOTE: If a monitor is mounted on the wing frame
it will be necessary to loosen the bolts holding the
monitor and slid the hose guide under the monitor.
Leave the monitor loose. This must be done be-
fore installing the 3/4" bolts. After tightening the
3/4" bolts retighten the bolts holding the monitor.
7. Route hoses through the wire rings.
NOTE: It may be necessary to loosen the hoses at
the gauge wheel cylinders to remove any twists in
the hoses.
8. Repeat all steps to install the hose guides to
the right-hand side of the drill.
9. Use the plastic wire ties to group the hoses to-
gether. Place the spiral hose wrap around the
hose at the pivot point between the center
frame and wing frame.
Figure 2
22777
Hose Guide
3/4" Bolt
1/4" Bolt
Hose Wrap
Wire Tie