Install 5-section wing fold – Great Plains 8500 FC User Manual
Page 2
2
FC Fold Bracket Update
Great Plains Manufacturing, Inc.
560-535M
05/24/2011
Install 5-Section Wing Fold
Move machine to level ground and unfold wings. Align
560-533H bracket
with 4 hole angled plate to bottom
side of Position 560-533H bracket
. Bracket should
slide from inside of machine until snug between wing
frame tube and fold bracket.
Refer to Figure 1
1.
Position 560-533H bracket
between wing frame
tube and fold bracket
(angled plate same angle as
fold bracket).
2.
Slide 806-079C u-bolt
over wing frame tube from
bottom and through holes of plate on bottom of
bracket
, secure with 5/8 lock washers and 5/8
nuts.
3.
Slide two 806-092C u-bolts
over top side of fold
bracket
and through holes of plate on top of
bracket
, secure with 1/2 lock washers and 1/2
nuts.
4.
Tighten all u-bolts and repeat same procedure for all
four fold brackets.
1
1
1
2
3
2
4
2
1
3
1
Null4:
Figure 1
Bracket Assembly
42159
4
2
1