Great Plains Planter Unit-Mount Row Cleaners - Manual (Page 11)

4/18/2006 204-085M
9 Maintenance and Lubrication
Yield-Pro® Single Unit Mount
Row Cleaner Installation
Single Arm
Refer to Figure 2
1. Assemble row cleaner to the row cleaner arm.
2. Insert the arm pivot bushings (5) in the upper
holes of the unit mount (3). Insert the bush-
ings from the inside and press until the shoul-
der of the bushing rests against the frame.
3. Insert the 1/2” x 1 3/4” carriage bolts (2) into
the row cleaner mount (1).
NOTE: Insert the bolts from the outside so the
nuts will be on the inside of the frame.
4. Thread on the 1/2” flange nuts (6) and hard-
ened washer (7). Tighten flange nuts.
NOTE: Single arm row cleaner mounts in lower
hole of unit mount.
Figure 2
Single Arm Assembly
22944
Maintenance
Proper servicing and adjustment is the key to the
long life of any farm implement. With careful and
systematic inspection, you can avoid costly mainte-
nance, time and repair.
After using your Yield-Pro® Row Cleaner for several
hours, check all bolts to be sure they are tight.
Storage
Clean the Yield-Pro® Row Cleaner as necessary.
For longer equipment life store inside if possible.
Maintenance and Lubrication