Operator’s manual – Great Plains DICKEY-john Seed Manager SE Operator Manual User Manual
Page 38
OPERATOR’S MANUAL
Seed Manager SE
11001-1359A-200810
36 / STARTUP
14A, 14D, and 14G. Shaft Speed Sensor Constant
The Shaft Speed Constant is the number of pulses the shaft speed sensor
generates in one revolution of the monitored shaft. This is typically the
number of teeth (sense points) on the gear attached to the monitored shaft.
The Shaft Speed Constant can be entered as a decimal with 0.01
resolution. Entering a value of zero (000.00) disables the shaft speed
function. The Shaft Speed Sensor Constant is accessible only if the
Number of Shaft Speed Sensors has a value other than 0. (
Figure 36
)
shows the display with a Shaft Speed Constant of 26.00 pulses per
revolution.
Figure 36
Shaft Speed Constant Display
14B, 14E, and 14H. Shaft Speed Sensor Hi Limit
This constant is the highest shaft speed (RPM) allowed before sounding a
warning alarm. The hi and lo warning limits are accessible only if the
Number of Shaft Speed Sensors has a value other than 0. The warning is
enabled or disabled by selecting the ON or OFF message. Use the
SELECT switch to advance one step to the right of the right most digit, then
press the SET switch to toggle between ON and OFF. (
Figure 37
) shows a
limit of 65 RPM with the warning enabled.
Figure 37
Hi Limit Shaft Speed Display