Great Plains 3S-4000 - Manual (Page 4)

194-209M 8/22/2006
Great Plains Mfg., Inc.
Acre Counter Update 4
Pulses per Mile
Press the FUNC button until the "PULSES" icon
appears in the display. The number in the display
indicates how many times the shaft rotates for ev-
ery mile driven.
There are 2 methods to enter the pulses per mile:
Refer to Figure 5
a. If you know the number, select it using the
UP and DOWN buttons. When you press
the FUNC button, the Landtracker will ac-
cept the number in the display as the new
pulses per mile.
Refer to Figure 6
b. If you do not know the pulses per mile,
press and hold the UP and DOWN but-
tons until "0000" appears in the display.
The "COUNT" icon will appear. The acre
counter is now counting shaft rotations.
Enter the cab and drive one mile. Press
the FUNC button to wake up the acre
counter. The "PULSES" and "COUNT"
icons will re-appear. The number dis-
played is the pulses per mile. Press the
FUNC button to accept the setting. The
"COUNT" icon will disappear. If you could
not drive a mile, you can calculate the
pulses per mile using a formula.
Note: If a password is set, you will not be able to
adjust the pulses per mile.
Width
Refer to Figure 7
Press the FUNC button until the "WIDTH" icon ap-
pears in the display. The number displayed is the
width of your implement in feet.
To adjust the width, press the UP and DOWN but-
tons. If a password has been entered, you will not
be able to adjust the width.
The width can be adjusted from 0 to 99.9 feet, in
tenths of a foot.
pulse count
distance in miles
pulses per mile =
PULSES
PULSES
CNT
WIDTH
FT
Figure 5
Figure 6
Figure 7