Great Plains 3N-40P User Manual
Page 2
Advertising
197-008M
6/1/2004
Great Plains Mfg., Inc.
Box Support Update
2
Refer to Figure 2
6.
Repeat steps one through three on the front
side of box.
7.
Remove template and install the two bolts
used to hold the template, in the two inside
holes, leaving three holes blank at the end of
the tray.
Refer to Figure 3
8.
Install the gusset using the 1/4" x 1" bolts and
1/4" flange nuts on the bottom side of the tray
flange and tighten. Using a transfer punch or
center punch, mark the 9/16" hole locations in
the end panel.
Refer to Figure 4
9.
Remove a gusset and drill a pilot hole through
the end panel.
Figure 2
Using template on Front Side
22534
Template
Figure 3
Using Transfer Punch
22535
Figure 4
Drilling Pilot Hole
22536
Advertising
This manual is related to the following products: