Great Plains John Kinze Planter Seed-Lok - Manual (Page 10)

206-013M 4/13/2009
8
Rotary Scraper Seed-Lok™ Mount-
ing Instructions for John Deere 7200
Consult page 12, Parts Section,
for all part (#) references:
1. Lower planter to ground.
2. Remove one gauge wheel by removing the bolt at
the wheel’s pivot point. Take note of spacers located
on the spindle to ensure the wheel is correctly re-
mounted.
3. Lift the depth control handle to its highest position.
4. Insert the edge of the Seed-Lok™ Mount (#3) in the
bottom of the opener body.
5. Turn the mount to a vertical position and slide for-
ward until the holes align with those of the opener
body, Figure 1 through Figure 4, Page 6.
6. Knock out the pins on the rotary scraper and drill the
holes out to 17/32" diameter, see Figure 9. Do this to
both scrapers.
7. With the scraper spring attached to both scrapers,
align the back scraper holes with the back holes of
the mount. Keep the scraper wheels on the inside of
the opener disk.
8. Secure the Seed-Lok™ mount and scraper by
screwing the bolts (#1), and spacers (#2) through
the opener body and into the flanged nuts (#4), on
the inside of the mount (#3).
9. Pull the scraper wheels back then slide forward on
the opener disks.
10. Align front holes, insert spacers and bolts with
flanged nuts.
11. Mount the wheel assembly to the mount by placing
the assembly on the bottom side of the mount and
fastening the carriage bolts and flanged nuts.
12. Follow the instructions in the " Adjustments", on
Page 9, to initially set your Seed-Lok™ Wheels.
13. Reinstall gauge wheels.
13382
Figure 9