Great Plains Series II Native Grass Agitator Vintage Drills - Manual

Great Plains Mfg., Inc.
Installation Instructions 1
©Copyright 2007 Printed 04/05/2007 202-609M
Series II Native Grass Agitator
Native Grass Vintage Drills
Used with:
• 705 and 1005 Native Grass Drills
• Some earlier Native Grass drills
General Information
These instructions explain how to install a Series II
Native Grass Agitator. These kits enhance your Great
Plains Native Grass Drill for more consistent and efficient
seeding of native grass. Kits are supplied for most Great
Plains Native Grass Drills. If your drill is not listed above,
have your dealer contact the factory, as a kit may be
available.
These instructions apply to:
The agitators in this kit are only for drills with
3 ⁄
4
in hexag-
onal agitator shafts in the seed box. If your drill does not
have a
3 ⁄
4
hex shaft, a shaft update kit may be available.
If your drill is a Series II, you already have the enhance-
ment in this kit.
For a complete Series II enhancement, separately order
seed sprocket kits below, and 2 decals:
Before You Start
Each kit converts one Native Grass seeding row. Order
one kit per row that can accept an agitator. Make sure
each row is not so close to a partition that no agitator can
be installed there.
Due to interference with partitions, it may not be possible
to install a full set of four agitators blades at all seed
cups. Due to partition re-alignments over various model
years, you may have blades left over after the upgrade.
Have the following at hand:
• Basic hand tools
• Updated Parts Manual for the drill
• Operator’s Manual for the drill
Notations and Conventions
“Left” and “Right” are facing in the direction of machine
travel.
202-608A NG SERIES II AGITATOR PER ROW
202-610A 705 NG 3/4 HEX SHAFT KIT
202-611A 1005 NG 3/4 HEX SHAFT KIT
202-597A NG CUP ENHANCEMENT KIT
(order one of these kits per row)
838-986C DECAL NATIVE GRASS SERIES II
Figure 1
Series II Agitator
26289
callouts identify components in the currently
referenced Figure or Figures.
to callouts reference new parts from the list on
page 6. The descriptions match those on the
cartons, bags or item tags, as well as your
updated Parts Manual.
to callouts reference existing parts. The descrip-
tions match those in your Parts Manual.
1
11 16
51 53