ADS Environmental Services Spider QR 775010 A0 - Manual (Page 70)

ADS Environmental Services ADS Spider User Manual
Page 68
Command Comment Example
(x is 1
–
8)
yyyy PULSE
CNx Pulse control x for 1 second
(x is 1
–
8) (PIN =yyyy)
1234 PULSE
CN4
GET REP Request Daily Report
(available only if e-mail option
installed) GET REP
Web Access NOTE: Before access to the Spider is available over
the Web, a special text message must be sent to the Spider to wake
it up. Refer to Appendix D: Remote Access Configuration and Quick
Start Guide on page 91 for further instructions and information.
After a Spider receives a text message command, it will interpret the
command and act on it. Invalid commands will be ignored. Valid
commands will be acknowledged with a return text message:
Location: OK Text Message command
Where,
“
Location
”
is the programmed Spider location
“
Text Message command
”
is the text message command
Therefore, once again using the programmed example, the
acknowledgement text message will be:
ADS DEMO STP: OK RST AL1
Control activation and deactivation commands may be protected with
a 4-digit PIN. If the PIN is set to
“
0000
”
, it is effectively disabled. Any
other 4-digit number will enable the PIN. You can change the PIN at
any time by accessing the Spider either remotely or locally with a
computer and entering the PIN, as described in Setting Location on
page 34.
NOTES:
1. Commands may be in lower case, upper case, or a
combination of both.