B&G Zeus2 Glass Helm CPU - Manual (Page 85)

If you select the AIS SART icon on the chart panel you will see the AIS MOB details.
Ú Note: If the MOB function is already active, this will be terminated and replaced by the new
route towards the AIS SART position!
Ú Note: If you ignore the alarm, the AIS SART icon remains visible on your chart, and the AIS
SART remains in the Vessels list.
Ú Note: If the AIS stops receiving the AIS SART message, the AIS SART remains in the Vessels list
for 10 minutes after it receives the last signal
Vessel alarms
You can define several alarms to alert you if a target shows up within predefined range limits,
or if a previously identified target is lost.
Alarm ID Description
Dangerous vessel Controls whether an alarm will be activated when a vessel comes
within the predefined CPA or TCPA. See "Defining dangerous vessels" on
page 87.
AIS vessel lost Sets the range for lost vessels. If a vessel is lost within the set range
this will trigger an alarm
Ú Note: The check box controls whether the alarm pop-up box is
displayed and if the siren will sound. The CPA and TCPA defines
when a vessel is dangerous regardless of the enabled/disabled
state.
Vessel message Controls whether an alarm will be activated when a message is
received from an AIS target
AIS | Zeus 2 Glass Helm 85