Bio-Rad LP Data View Software for BioLogic LP System - Manual

Note: Due to the ease of use of the LP Data View software, a conventional “hard copy” instruction
manual is not included. This Installation and Operation guide will enable you to install and use the
software. See the on-line HELP function of LP Data View for additional information about features of
this program.
Computer requirements
PC with one available serial port and with Windows 95, Windows 98, Windows ME, Windows NT
version 4.0, or Windows 2000 operating systems.
Section 1
Setting up LP Data View with the BioLogic LP System
1. Ensure that both the BioLogic LP system and the computer are both turned off.
2. Connect the serial cable (supplied with the software) from the COMM port on the rear of the
Biologic LP System to either COM 1, COM 2 or COM 3 on the computer. You may need to use the
supplied port adapter. Note that 25 feet is the maximum serial cable length supported by the
BioLogic LP system and LP Data View at this time.
3. Turn on the computer.
4. If LP Data View version 1.00 is already installed on the computer it should be uninstalled
before installing version 1.01.
i. Go to Start, Settings, Control Panel, Add/Remove Programs.
ii. Select LP Data View from the list of installed programs
iii. Click on the Add/Remove button
iv. Follow the screen prompts to remove LP Data View version 1.00.
5. Install LP Data View version 1.01.
i. Insert the LP Data View CD.
ii. Go to Start, Settings, Control Panel, Add/Remove Programs
iii. Click on the Install button
iv. Follow the screen prompts to install LP Data View.
6. Turn on the BioLogic LP System and then launch the LP Data View application from the computer.
Installation and Operation of LP Data View
Software for the BioLogic LP System