Bio-Rad LP Data View Software for BioLogic LP System - Manual (Page 2)

7. LP Data View uses COM 2 as the default port. If another COM port is used, after a brief
pause, you will see a dialog box reading;
No data is being received
OK
Setup Exit
If you receive this message, click on the Setup button. Another dialog box will ask you to
select the correct COM port. Make your selection and then click on the OK button.
8. You should now see the main Chromatogram Run screen with the Receive indicator light
green.
9. Congratulations! You are now ready to record your data.
Sections 2 and 3 provide a brief explanation of how to use LP Data View. A more comprehensive
explanation can be found by selecting the on-screen HELP function.
Section 2
Using LP Data View as an electronic chart recorder
To monitor pre-Run column equilibration steps
1. Click on Record. LP Data View will act just like a chart recorder and record UV and
conductivity data from the BioLogic LP. You may scale the axes at any time. To stop recording,
click on Stop.
2. To clear the screen, click on Clear.
Recording Method steps
1. If you wish to view and print the Method before it is run, use the following procedure.
i. Close any Run you are viewing and use the Clear button or Chart Recorder tab to
obtain a blank chart recorder screen.
ii. Click on the Record button.
iii. Go to the BioLogic LP System and press the Program hardkey.
iv. Select List of Methods. Select your Method of interest and open it using the Open
softkey.
v. Press the Program hardkey again (the key light will remain on).
vi. Press the Export softkey to send the Method to LP Data View.
vii. The Method may now be viewed in LP Data View by clicking the Method button. Click
the Print button to access the print dialog box where you can choose to print just the
Method.