Bio-Rad Bio-Rex® Reactor Grade Resins User Manual

Page 4

Advertising
background image

5

6.

Slowly pour the solution to be deionized into the
reservoir above the column, then elute slowly through
the column taking care not to disturb the resin bed.
Discard the first 1-2 bed volumes of the solution.

7.

The quality of the deionized solution may be verified
by measuring its conductivity against the conductivi-
ty of the starting solution.

Table 2. Guidelines for Column Deionization

Approximate Volume

Column Size

Weight of

of Deionized Water*

(diameter x length)

Resin (g)

(liters)

0.5 x 20

2.6

1.5

1.0 x 50

27.0

6.7

1.5 x 100

118.0

29.0

2.5 x 100

325.0

80.0

5.0 x 100

1,300.0

325.0

15.0 x 120

13.6

3,500.0

* Based on using 100 ppm NaCl. This volume will vary depending on ini-

tial water quality.

The dye (D) form of resin may be used to deionize

solutions until the dye begins to fade from blue to gold,
indicating capacity is exhausted. In a large column, the
dye will change color starting at the top of the column,
and deionization will continue until the color change

Column Method

Use mixed bed resin in a column to deionize larger

volumes (liter volumes) of mobile phase such as water.
The following procedure gives guidelines for column
deionization for a range of volumes; use Table 2 to select
the column size and quantity of resin.

1.

Select a column with a length to diameter ratio of at
least 5 to 1. Refer to Table 2.

2.

Weigh out approximately 0.6 grams of resin for every
1 ml of column volume.

3.

Using the resin as it comes from the bottle, pour a
small portion of resin into the column. Pour the col-
umn in sections, a scoop at a time, to prevent separa-
tion of the anion and cation resins. Add water,
keeping about 1/4 inch of water above the resin.

4. Repeat step 3, alternating resin and water, until the

total amount of resin is added. The resin will have a
tiger's tail appearance; more bands will mean a higher
efficiency. Remove any trapped air bubbles by tap-
ping the column during packing.

5.

When the column is packed, wash the resin with 3
bed volumes of deionized water. Discard wash.

4

LIT205B 6/17/98 12:15 PM Page 4

Advertising
This manual is related to the following products: