BlueAnt V1x Voice Controlled Headset - Manual (Page 17)

ENGLISH
BlueAnt
17
11. Volume level: Click Volume or Volume during a call to adjust the desired level. Volume changes will be
remembered for the next call. Be sure to use the headset at a comfortable and safe volume level. Note: Volume levels for
Voice Prompts and Active calls are independent.
12. Mute/Unmute the microphone. Press and Hold Vol and Vol for 3 seconds during a call.
Advanced Headset Functions
1. Disconnect / Transfer: To transfer the audio to the phone, Click Volume and Volume together once. To transfer audio
back to the V1, Click Volume and Volume together again
2. Disable/Enable the LED indicators: (for night time driving): When your headset is in idle or standby mode Press and
Hold
Volume and Volume together for 3 seconds. After turning the headset OFF and back ON, the LED Indicators
will be active again by default. Note the LED’s are turned OFF while a call is active.
3. Turn Voice Control ON/OFF: Press and Hold Vol and Vol for 6 Seconds
4. V1 Reset: To reset the V1 to factory settings; while in idle mode (not connected to any device), Click Volume ,
Volume
and BAB together (3 buttons). The V1 will refresh its memory, delete all current pairing information and
the welcome message will play in the headset.