Cooper Instruments & Systems LTL 730 Wireless Tension Link Load Cell - Manual (Page 15)

CF 150 LTL 730 12 12/08
6. Select a databit value using the Sel keys to toggle between the two choices; 7 or 8 (default). Press Enter to
accept the setting. The following display appears.
7. Select a mode of communication you want using the Sel keys to scroll through these choices; Continuous, ,
Poll, Remote and Prink Key Only. Press Enter to accept the setting.
If you choose Continuous, you will be prompted to select a print format for the transmission and a rate at
which you want to send the transmission.
If you choose Poll you will be prompted to enter a poll character.
Choose Remote for wireline communications.
Choose Print Key Only to print only when the Print key is pressed.
8. Repeat steps 2-7 for the other serial port if it needs configuring.
9. Press ESC to return to the first soft key set of the Configuration menu.
If you enable the radio:
You are asked to enter a Radio Channel. Your LTL 730 and Communicator must be on the same channel to
function together. Key in a number from 1 through 64. 1 is the default setting. Press Enter to accept.
You are asked to enter a Network ID#. This is a unique address number (1-15) so the Communicator only
speaks to one instrument at a time without “cross-talking.” Use the available soft keys to enter a number (1-15),
then press Enter to accept.
You are then asked to key in an alternate network identifier. Use the available soft keys to enter alpha
characters, then press Enter to accept.
Config Mode
The next menu key is the Mode key. Use this key to choose what display mode is active upon powerup.
1. Press the Mode key. The following is displayed:
See the Display Modes section under LTL 730 Operation for more detail on
display modes.
Asterisk shows current selection. (Last) causes display to power up in same
mode as when last powered down.