Display, Display assembly, Removing the display assembly – Dell Inspiron 1545 User Manual
Page 23
Back to Contents Page
Display
Dell™ Inspiron™ 1545 Service Manual
Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the center control cover (see
Removing the Center Control Cover
).
3.
Remove the base cover (see
Removing the Base Cover
).
4.
Disconnect the Mini-Card cables from the Mini-Card, if applicable.
5.
Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from their routing guides.
ATI Mobility Radeon:
Mobile Intel® GMA:
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working inside the
computer.
NOTICE:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not
covered by your warranty.
NOTE:
The location of the Mini-Card may change according to the display adapter supported by your computer. To find the type of display adapter on
your computer, click Start® Control Panel® System® Device Manager® Display adapters.