Canon LIDE 80 - Manual (Page 15)

Scanning Film
13
7
Open the document cover and
remove the Film Adapter Unit.
To continue scanning your film, follow the
Scanning Film steps.
Scanning Film
The following steps explain how to scan films with ArcSoft PhotoStudio and ScanGear CS.
1
Place the film in the Film Guide.
Place the film face up in the Film Guide (images
and words should read correctly from above) with
the spaces between frames aligned with the white
lines on the guide.
2
Remove the CAP from the Film Adapter Unit
and gently set the unit over the frame you
wish to scan.
3
Gently close the document cover.
4
Start ArcSoft PhotoStudio.
Select [Start], [Programs] or [All Programs], [ArcSoft PhotoStudio] and [PhotoStudio 5].
Double-click the [Applications (Mac OS 9)] and [PhotoStudio] folders and the
[PhotoStudio] icon.
• Clean the document glass before placing the Film Guide on it, otherwise dirt and dust
can affect image quality or damage the film.
• Use a blower brush to remove any dust from the film, which will affect the image
quality, and take care to hold the film by its edges to avoid transferring dirt or
fingerprints to it.
• Do not move the Film Adapter
Unit once it has been placed on
the Film Guide. Sliding it may
scratch the film.
• The document cover does not touch the document glass completely. Be careful not to
force the document cover down.
• Do not press down on, or rest your hands on, the document cover.
Put the CAP back
on the Film
Adapter Unit.
White Line
Position the Film Adapter Unit so that its align-
ment tab is aligned with the Film Guide.