Canon LIDE 80 - Manual (Page 17)

Scanning Film
15
11
Save the scanned image.
Click the [File] menu and select [Save As]. Select the folder
where you wish to store the image file, enter a file name,
select a file type (JPG format is recommended) and click [Save].
Post Film Scanning Procedures
1
Open the document cover, remove the Film Adapter Unit and replace its CAP.
2
Remove the film and the Film Guide from the document glass.
• You can purchase the following Accessory Kit for CanoScan LiDE80 if the Film Guide, Film
Adapter Unit or its CAP are lost or damaged.
Accessory Kit (A)(CSAK-LiDE80A) : Film Guide, CAP for Film Adapter Unit
Accessory Kit (B)(CSAK-LiDE80B) : Film Guide, Film Adapter Unit (with CAP)
Calibration Message
You must calibrate the scanner if the message to the
right appears. Use the following procedures to
calibrate it.
1. Open the document cover and remove the Film
Adapter Unit.
2. Remove the film from the Film Guide and position the Film Adapter Unit over the first frame
(closest to the scanner’s front) of the empty Film Guide on the document glass.
3. Gently close the document cover and click the [OK] button.
The calibration process will start and finish after approximately 1 minute.
4. Put the film back in the Film Guide once the calibration process is complete and place the
Film Adapter Unit back over the frame you wish to scan.
5. Click the [OK] button to display the preview image.
• If the scanner does not perform as described above, read the "Troubleshooting" section
of the Scanning Guide (HTML format manual).
• For details about the bundled software programs, read the Scanning Guide or the User’s
Guide (PDF format manual) for each software program on the CanoScan Setup Utility
CD-ROM.
• Always put the CAP back on the Film Adapter Unit when it is not in use.
• Film may be damaged if it is left on the document glass for extended periods of time.