Bissell 20N4 - Manual (Page 19)

M
aintenance and care
Brush removal and large belt replacement
brushes can be removed for cleaning or
replacement as needed.
1. Follow small belt removal Instructions on
page 18.
2. Remove brush rolls by pulling them off of
the metal rods.
3. Place cleaned or new brush rolls back onto the
rods. make sure one washer is on each end of
the rollers prior to sliding onto the rod. Be sure
to let the rod slide through the bushing to
insure proper fit.
4. Re-attach the long belt on the bottom to the
cogs of the small roller brushes.
5. Place small belt over back roller and
metal cog.
6. Place pivot arm in place and screw in place
using the silver screw.
7. Re-attach clear end cap by tightening with
the (2) black screws.
8. Return front nozzle to front of unit, by
latching from underneath and then securing
with a screw.
If you have any questions or are having trouble
installing or replacing you belt(s) or brushes,
please call bISSEll consumer Services
WaRNING:
to reduce the risk of fire,
electric shock or injury,
unplug from the outlet
before servicing.
19
w w w . b i s s e l l . c o m
2. 3.
4. 5.
6. 7.
8.
T
roubleshooting
built-in heater ready light does not illuminate
possible cause Remedies
1. The heater switch is not turned oN ( I ). 1. Turn the heater switch oN ( I ).
2. The power switch is not turned oN ( I ). 2. Both switches must be oN ( I ) to
activate the heater ready light.
Reduce Spray or No Spray
possible cause Remedies
1. 2-in1 water tank may be empty. 1. Fill heavy duty bladder with hand hot
tap water.
2. Formula tank may be empty. 2. Fill formula tank with water and
BISSELL 2X concentrated formula.
3. 2-in-1 water tank may not be 3. Turn power off ( O ). Remove and
seated completely. reseat tank.