Bissell 53U6E - Manual (Page 10)

w w w. b i s s e l l . c o m
O
perations
10
Carpet cleaning
1. Plug the deep cleaner into a proper out-
let. Set ReadyTools dial to the FLOOR
CLEANING setting. Turn the power on by
pressing the red power switch on the back
of the unit with your foot. Turn heater
switch (located on side of unit) to the on
position. Allow one minute for the built-in
heater to warm up before cleaning.
NOTE: The CleanView ® ProHeat ® will
be fully warmed and will
provide optimal performance
after one minute of continuous heat-
ed cleaning.
2. With your foot, press the gray handle
release lever located on the back of unit
below water tank to detent handle.
3. While pressing the spray trigger, make
one slow forward wet pass and another
back. Let the built-in heater, BISSELL 2X
deep cleaning formula and DirtLifter
PowerBrush do the work for you.
Caution: Do not overwet.
4. Release the spray trigger and make one
slow forward and backward pass over the
same area to remove any residual dirty
water and aid in drying.
5. Repeat cleaning passes until solution
being suctioned up appears clean.
Continue passes without pressing the
spray trigger until you can’t see any more
water being suctioned up.
Empty the 2-in-1 water tank/
clean removable nozzle
1. Turn power switch off. Remove the 2-in-1
water tank from the base using the tank
carry handle. Carry the tank like a bucket to
a utility sink or outside where you will
dispose of the collection water. Remove the
top of the tank by rotating the handle for-
ward to unlatch lid and lifting lid off tank.
2. Empty collection water from bottom of tank.
3. After each use, remove and rinse the lint
screen located on the tank lid.
4. If nozzle needs to be cleaned, remove by
grasping handle at the top and pulling
forward. Clean removable nozzle by
rinsing under running water.
Tip:
Thorough vacuuming before deep
cleaning will prevent early clogging
of the lint trap.
Handle Release Power Switch
Heater Switch
1.
3.
2.
4.
Lint Screen