Bissell 53U6E - Manual (Page 14)

w w w. b i s s e l l . c o m
O
perations
M
aintenance and care
14
Hard Floor Cleaning continued
9. Repeat the motion without pressing the
spray trigger using the hard floor tool to
squeegee and suction up the dirty water.
10. When finished, remove hard floor tool,
rinse and let dry before storing. Refer
to the Maintenance and care section on
page 15 for machine clean up and
storage instructions.Machine care
Machine care
For best results, a few simple steps can assure
your machine is well maintained after cleaning
is complete.
1. Flush your machine of any remaining
residual solution.
a. Fill the 2-in-1 clean water tank
(bladder) with clean hot tap water.
b. Plug your machine into a proper outlet
and set the ReadyTools dial to the "FLOOR
CLEANING" setting. Turn the power on by
pressing the power button.
c. Recline the handle and press the spray
trigger for 15 seconds while making forward
and backward passes on carpet. Release
the trigger to suction. Repeat for another 15
seconds. Continue without pressing the trigger
until there is no more water being suctioned.
2. Turn power switch off. Unplug the machine
and wrap the power cord.
3. After emptying the 2-in-1 water tank, rinse
with running hot tap water, taking care to
clean underneath and around the heavy duty
bladder. Clean out red lint screen (located
on tank lid). Removable nozzle may be
rinsed if necessary.
4. Before you place the 2-in-1 water tank back
onto the machine, remove the red solution
filter cap (on the base of the machine).
Remove the cap by inserting a coin or a flat
head screwdriver into the slot on the top.
Turn counter clockwise to unscrew.
WARNING:
To reduce the risk of electric
shock, or injury, unplug from
the outlet before servcing.
4.