Bissell 59M5E - Manual (Page 10)

w w w . b i s s e l l . c o m
M
aintenance and care
10
WARNING:
To reduce the risk of
injury from moving parts,
turn the power switch OFF
and disconnect plug from
electrical outletbefore
performing maintenance
or troubleshooting checks.
Dust bag replacement
1. Unplug the vacuum from electrical outlet.
2. Open the dust bag compartment by
lifting up on the latch on the door on
the front of the vacuum.
3. Lift out the dust bag holder and
dust bag.
4. Release the dust bag from the holder
by pressing the dust bag holder clip
and pulling the dust bag out of the
holder. Discard the used dust bag.
5. Slide the new dust bag into the holder
by inserting the dust bag into the tabs
located at the bottom of the holder.
Then press the dust bag holder clip,
insert the dust bag and release the
dust bag holder clip to hold the dust
bag in place.
6. Place holder and new dust bag back
into the dust bag compartment, mak-
ing sure the entire bag is tucked in
below the seal gasket.
7. Close dust bag compartment door
and press down gently until it locks
into place.
NOTE: The dust bag compartment
door will not close without the
dust bag in place.
2.
3.
4.