Bissell 59M5E - Manual (Page 12)

w w w . b i s s e l l . c o m
M
aintenance and care
12
The post-motor filter is a H13 HEPA
media filter* which assists in the
filtration process to return clean air
to the room.
1. Unplug the vacuum from electrical outlet.
2. Remove the filter door (located on the
rear of the vacuum) by pulling up on
the filter door latch.
3. Remove the post-motor filter by grasping
the lip of the filter frame and pulling up.
4. Replace the post-motor filter with a
new filter.
NOTE: The post-motor filter is a
white, pleated HEPA media filter.*
This filter is NOT washable and
must be replaced when it becomes
dirty.
5. Replace the filter door by inserting the
two tabs at the top of the filter door
and pushing down on the bottom of
the filter door.
1. Unplug the vacuum from electrical outlet.
2. If a clog is present or debris is visible,
turn the collar on the neck of the
TurboBrush Pet tool counterclockwise
to the unlocked position to remove the
faceplate and clear any obstructions.
3. To clean debris from the brush,
remove the brush from the drive belt
and clean debris.
4. Reposition the drive belt on the brush.
Place the ends of the brush in the slots
on the sides. Reposition the faceplate
and turn the collar clockwise to the
locked position.
Replacing the post-motor HEPA media filter*
Maintaining the TurboBrush ™ Pet tool
Post-Motor
HEPA Media
Filter*
2
.
3.
*The Filter Media, not the vacuum as a whole, complies with the High Efficiency
Particulate Air (HEPA) filter specification (EN 1822-1:2009).