Cisco CIVS-IPC-2500 User Manual

Page 56

Advertising
background image

3-36

Cisco Video Surveillance System IP Camera User Guide

OL-14220-01

Chapter 3 Configuring and Managing the IP Camera

Status Windows

LOG: Clear all messages.

You have used the Clear Log button to delete the
log file from the IP camera SDRAM.

LOG: Log file is full. Start to wrap around.

The IP camera SDRAM is full and existing log
information is beginning to be overwritten.

Network: Failed to get the IP address. Camera set
to default IP address.

IP camera is unable to obtain an IP address
through DHCP and is set to the default IP address
of 192.168.0.100.

Network: LAN activated.

IP camera obtained a network IP address.

NTP: Failed to synchronize data & time with the
NTP server.

Provides information when you configure the IP
camera to obtains its time from an NTP server.

NTP: No NTP server specified.

NTP: Synchronization OK.

NTP: The NTP server cannot be reached.

output: Failed to set output port Port_Number.

Provides information when you configure the
output ports on the IP camera.

output: Set output port Port_Number to high OK.

output: Set output port Port_Number to low OK.

output: Set output port Port_Number to pulse OK.

PTZ: Go to Preset Position_Number.

Provides information when you pan or tilt the IP
camera or it move it to a preset position.

PTZ: Move down.

PTZ: Move left.

PTZ: Move right.

PTZ: Move up.

PTZ: Zoom in.

PTZ: Zoom out.

Stream: HTTP stream started. [id: User, ip:
Address]

Provides information when a user accesses (HTTP
stream started) or exits (HTTP stream stopped) the
Home window.

User is the IP camera user name of the user.
Address is the IP address of the PC that was used.

Stream: HTTP stream stopped. [id: User, ip:
Address]

Stream: RTSP stream started. [ip: Type, UDP:
Address_1:Port_1 -> Address_2:Port_2, User]

Provides information when an RTSP stream from
the IP camera is initiated (RTSP stream started) or
stopped (RTSP stream stopped).

Type is the type of stream (Video or Audio).
Address_1:Port_1 are the IP address and port
number of the IP camera. Address_2:Port_2 are IP
address and port number of the device that
receives the stream. User is the IP camera user
name of the user who started or stopped the
stream.

Stream: RTSP stream stopped. [ip: Type, UDP:
Address_1:Port_1 -> Address_2:Port_2, User]

System: Cancel upgrade process

An IP camera administrator cancelled a firmware
upgrade that was in process.

Table 3-24

Syslog and Log Information (continued)

Message

Explanation

Advertising