Dynalco SWT-2000 Speed Switch/Speed Transmitter - Manual (Page 16)

Operating Instructions SWT-2000 DYNALCO
12
6. Configuration via PC Software
6.1 Software Concept
The SWT-2000 Ethernet connection is used to configure or interrogate the unit. (see Paragraph 9
Accessories) The resident menu driven configuration software is used for unit set up.
Normal PC file handling procedures apply and the configuration file can be communicated between computer
and SWT-2000.
To run the Software you must have Java Runtime Environment (JRE) 1.5 or higher.
6.2 PC Settings
The PC Ethernet card must first be set correctly. SWT-2000’s cannot be used on a network.
Go to Desktop, Settings, Network connections and right click on <Properties>. Right click the Network card
you want to use for SWT-2000 comms and select <Properties>.
Select Internet protocol (TCP/IP) and select the Option <IP-Address automatically recognize>
6.3 Download Configuration Software
Connect the Tachometer to your PC using a cross over patch cable. Once connected open your browser and
enter the IP address 192.168.1.127/software
An HTML page will open with the Link <Download control program>
Click on the Link. Dependent upon your Internet Explorer configuration you will be asked whether you want to
<Open> (Run) or <Save> (Save as) the program.
Direct Execution
Select <Open> and the configuration will be read from the tachometer (can take a few seconds). Once loaded
the configuration software will open automatically.
Save As
Select <Save> to save the file in a path of your choice (can take a few seconds).
Open the file from your PC. The configuration software establishes a connection to the SWT-2000 and reads
the actual parameters.