Dynalco SWT-2000 Speed Switch/Speed Transmitter User Manual
Page 18
Operating Instructions SWT-2000
DYNALCO
14
6.5.2 …resetting to factory default
To reset parameters to factory settings go to <Settings> <Back to factory setup> then click on OK.
Note
: If you have not saved the live parameters, they will be lost.
6.5.3 …loading
To load an existing file go to <File>, <Open> and select the required configuration file.
Note
: If you have not saved the live parameters, they will be lost.
6.5.4 …saving
To save actual parameters go to <File>, <Save as> and choose the path and file name you want to use.
Please note that the file name ends in the format *. SWT-2000.
6.5.5 …printout
To print actual parameters go to <File>, <Print> and choose your printer. 9 pages will be printed.
6.6 Communication with the SWT-2000
6.6.1 Read Measured Data
To read actual measured data and unit status go to <Online>, <Start – read measure data>.
Measured data is updated in the Main window with interval defined under <Settings>, <Refresh Interval>.
¼
Second
½
Second
1 Second
2
½
Seconds
5
Seconds
10
Seconds
To end the measured data display go to <Online>, <Stop – read measure data>.
6.6.2 Reading Configuration from the SWT-2000
When the configuration software is started the configuration file is automatically transferred to the PC. To up
load the file again go to <Online>, <Read parameters> and confirm with Enter.
Note
: The live parameter data will be overwritten.