Edge Lighting Form Round & Square MR16 - Manual (Page 2)

2
Install the Fixture to Monorail Connector (MC-FJ-_)
1: Place the Fast Jack housing onto the Monorail and use
fingers to tighten the Fast Jack housing connector to the Fast
Jack housing. Make sure that the Fast Jack housing
connector is not cross threaded.
2: Use fingers to tighten the Fast Jack fixture connector into the
Fast Jack housing connector.
C
Install the Fixture to Monorail
2 Circuit Connector (M2C-FJ-_)
FAST JACK
HOUSING
1
FAST JACK HOUSING
CONNECTOR
FAST JACK
FIXTURE
CONNECTOR
2
2
MONORAIL
D
1: Place the Fast Jack housing onto the Monorail 2 Circuit and
use fingers to tighten the Fast Jack housing connector to the
Fast Jack housing. Make sure that the Fast Jack housing
connector is not cross threaded.
2: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack housing connector.
FAST JACK HOUSING
CONNECTOR
FAST JACK
HOUSING
1
FAST JACK
FIXTURE
CONNECTOR
2
2
MONORAIL 2 CIRCUIT
1: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack canopy connector.
FAST JACK CANOPY
CONNECTOR
FAST JACK FIXTURE
CONNECTOR
F
E
3: To power the fixture from circuit #1, top and bottom
(neutral) rails, tighten the #4-40 set screw on top of the
housing with the 0.05 Allen wrench. Make sure this set
screw connection is very tight.
4: To power the fixture from circuit #2, middle and bottom
(neutral) rails, remove the #4-40 set screw from top of the
housing and tighten it into the side threaded hole with the
0.05 Allen wrench. Make sure this set screw connection
is very tight.
NOTE:
set screw to select a circuit on the Monorail 2 Circuit connector.
To avoid shorting the system, do not use more than one
NOTE: Do not load either circuit over the maximum system
rating.
Install the Fixture to Fast Jack
Canopy (FJP-2SQ-_, FJP-4SQ-_,
FJP-4RD-_)
#4-40 SET
SCREW
0.05 ALLEN
WRENCH
3
4
1
1
CIRCUIT #1 CIRCUIT #2
1
2
N
1
2
N