Edge Lighting Harley with Gobo - Manual (Page 3)

3
G
12: Install the harley with the gobo to the corresponding
system by referring to drawing H through K on page 3
and 4.
14: If necessary add the second magnifying lens holder ring
(without metal trim-included) to increase the magnified
image size.
15: To increase the image size even bigger, add the third
magnifying lens (optional-sold separately).
13: First use the magnifying lens holder with the metal trim.
Place the magnifying lens holder holes onto the metal rods
by sliding the magnifying lens holder. When focused image
is achieved, tighten the thumb screws.
MAGNIFYING LENS
HOLDER RING
METAL ROD
THUMB
SCREW
13
15
NOTE:
intensity of the image gets dimmer as the fixture is installed
farther from the wall.
The projected gobo image on the wall gets larger and the
Install the Fixture to Monorail
Connector (MC-FJ-_)
1: Place the Fast Jack housing onto the Monorail and use
fingers to tighten the Fast Jack housing connector to the Fast
Jack housing. Make sure that the Fast Jack housing
connector is not cross threaded.
2: Use fingers to tighten the Fast Jack fixture connector into the
Fast Jack housing connector.
H
FAST JACK
HOUSING
1
FAST JACK HOUSING
CONNECTOR
FAST JACK
FIXTURE
CONNECTOR
2
2
MONORAIL
I
FAST JACK HOUSING
CONNECTOR
FAST JACK
HOUSING
1
FAST JACK
FIXTURE
CONNECTOR
2
2
MONORAIL 2 CIRCUIT
Install the Fixture to Monorail
2 Circuit Connector (M2C-FJ-_)
1: Place the Fast Jack housing onto the Monorail 2 Circuit and
use fingers to tighten the Fast Jack housing connector to the
Fast Jack housing. Make sure that the Fast Jack housing
connector is not cross threaded.
2: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack housing connector.