Edge Lighting Phi Pro Aim MR16 - Manual (Page 4)

2
4
Install the Fixture to Fast Jack Canopy (FJP-2SQ-_, FJP-4SQ-_,
FJP-4RD-_)
L
1: Loosen the top M4 set screw on the Phi arm with the 2MM
Allen driver.
2: Remove and discard the Phi housing connector.
FAST JACK CANOPY
CONNECTOR
FAST JACK FIXTURE
CONNECTOR
M
3
4
3: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack canopy connector.
4: Tighten the top M4 set screw with the 2mm Allen driver to
secure the fixture in place.
2MM ALLEN
DRIVER
TOP M4 SET
SCREW
TOP M4 SET
SCREW
2MM ALLEN
DRIVER
PHI HOUSING
CONNECTOR
(DISCARD)
1
Pro-Aim Positioning and Locking the Phi
N
1
2MM ALLEN
DRIVER
BOTTOM M4
SET SCREW
1
by tightening the bottom M4 set screw with the 2mm Allen
driver. : Rotate the fixture to the desired position and lock it in place
O
2MM ALLEN DRIVER
2
2: Use the 2mm Allen driver on the bottom of the Phi arm to tilt
the head up or down.
P
3
2MM ALLEN DRIVER
SHADE
3
front of the shade to rotate the lens to the desired position.
Tighten the M4 set screw to lock the lens in position. : Place the 2mm Allen driver into the M4 set screw on the