Edge Lighting Crystal Spirit - Manual (Page 4)

CIRCUIT #1 CIRCUIT #2
1
2
N
1
2
N
L 11: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack system connector (Monorail, Monorail Wall,
Monorail 2 Circuit, or multi-port and mono-point canopies.
Refer to the instructions provided with the system
connector or canopy).
12: Refer to the instructions provided with the Monorail 2
Circuit fixture connector to choose the Circuit #1 or Circuit
#2.
11
11
11
11
11
12
12
11
11
Replacing the Lamp
4
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
M
1: Reach the lamp shield through the hanging crystals and
remove it.
2: Remove the old lamp.
3: Follow steps 3 & 4 in "Install the Fixture" to install the new
lamp.
SPRING CLIP
OLD LAMP
LAMP SHIELD
2
1
Balancing the Fixture (Optional)
N
NOTE: In some cases fixture may be sightly off balanced, follow
steps 1 through 3 to adjust the fixture.
1: Carefully loosen cylinder connector and the beveled washer
(do not remove) about one thread.
2: Slide the fixture assembly towards the direction of the
sagging.
3: Once the fixture is balanced tighten the beveled washer and
cylinder connector to secure fixture in place.
NOT
BALANCED
CRYSTAL DROPS NOT SHOWN
TO AVOID CONFUSION
CYLINDER CONNECTOR
FIXTURE ASSEMBLY
FABRIC SHADE
3
2
1
BEVELED WASHER