Replace the lamp – Edge Lighting King's Crossing User Manual
Page 4
Advertising
11: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack system connector (Monorail, Monorail 2
Circuit, or canopy connector - Refer to the instructions
provided with the system connector or canopy).
12: Refer to the instructions provided with the Monorail 2
Circuit fixture connector to choose Circuit #1 or Circuit #2.
3
CIRCUIT #1
CIRCUIT #2
1
2
N
1
2
N
O
11
11
11
11
11
11
12
12
Replace the Lamp
P
1: Carefully, remove one pin screw from the housing post to
remove the housing post assembly.
GLASS SHADE
PIN SCREW
HOUSING POST
ASSEMBLY
1
2: Carefully pull the lamp shield off the spring clips, and
remove the old lamp.
3: Follow the steps "Install the Lamp" on page 1 & 2 to install
the new lamp and the housing assembly.
Q
LAMP SHIELD
SPRING CLIP
2
Advertising