Edge Lighting Quattro LED - Manual (Page 2)

2
9: Push the strain relief tube completely into the coaxial
fixture connector. Make sure the slot on the strain relief
tube is not inline with the M4 set screw.
10: Tighten the M4 set screw with the 2mm Allen wrench.
F
9
10
2MM ALLEN WRENCH
M4 SET SCREW
STRAIN RELIEF TUBE
COAXIAL FIXTURE
CONNECTOR
E
1.5MM ALLEN WRENCH
M3 SET SCREW
WRINKLE
OUTER METAL JACK INNER WIRE
6
7
8
6: Keep feeding the coaxial cable in until the inner wire is
visible in the screw hole of the fixture connector tip. The
outer metal jacket will start to wrinkle.
7: Hold the fixture connector in place. Replace and tighten the
M3 set screw on fixture connector tip with the 1.5mm Allen
wrench.
8: Pull down the outer metal jacket to smooth the wrinkles.
1
2
N
1
2
N 11
11
12
12
11: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack system connector (Monorail, Monorail 2
Circuit, or canopy connector - Refer to the instructions
provided with the system connector or canopy).
12: Refer to the instructions provided with the Monorail 2
Circuit fixture connector to choose Circuit #1 or Circuit #2.
CIRCUIT #1 CIRCUIT #2
G
11
11
11
11
NOTE: The Quattro LED head consumes 6 watts and contains
integrated LED lamps which are rated for 50,000 hours.