Install the monorail to power feed canopy – Edge Lighting 2" Power Feed Canopies User Manual
Page 2
Advertising
2
Install the Monorail to Power Feed Canopy
c
CAP
3/8-24 SET SCREW
POWER HOUSING
2
1
1: Unscrew the cap from power housing.
2: Slightly loosen the 3/8-24 set screw on the cap with the
3/16 Allen wrench provided, DO NOT REMOVE IT.
D
MONORAIL
POWER HOUSING
CAP
3: Place the Monorail into the power housing. Make sure that
the Monorail is supported by the standoffs. Refer to the
instructions provided with the standoffs.
4: Tighten the cap to the power housing. Make sure the cap
is not cross threaded.
5: Tighten the 3/8-24 set screw with the 3/16 Allen wrench
provided on the cap firmly for proper power connection.
E
CAP
5
3
4
3/16 ALLEN WRENCH
3/8-24 SET SCREW
3/16 ALLEN WRENCH
Advertising