Install the monorail to power feed canopy – Edge Lighting 4" Power Feed Canopies User Manual
Page 2
Advertising
C
CAP
3/8-24 SET SCREW
POWER HOUSING
2
1
3/16 ALLEN WRENCH
CAP
2
1: Unscrew the cap from power housing.
2: Slightly loosen the 3/8-24 set screw on the cap with the
3/16 Allen wrench provided, DO NOT REMOVE IT.
D
3: Place the Monorail into the power housing. Make sure that
the Monorail is supported by the standoffs. Refer to the
instructions provided with the standoffs.
4: Tighten the cap to the power housing. Make sure the cap
is not cross threaded.
MONORAIL
POWER HOUSING
CAP
E
3/8-24 SET SCREW
5: Tighten the 3/8-24 set screw on the cap firmly with the 3/16
Allen wrench provided for proper power connection.
3
4
5
Install the Monorail to Power Feed Canopy
3/16 ALLEN WRENCH
Advertising