Edge Lighting Adjustable Power Feed - Manual (Page 2)

5: (OPTIONAL) To shorten the adjustable power feed cable,
loosen the four M3 set screws on the male end connector
(Do Not Remove) with the 1.5mm Allen wrench provided.
6: Remove the male end connector and trim the adjustable
power feed cable to the desired length.
7: Strip 3/8" off of the insulation from the end of the wires.
8: Insert the stripped portion of the wires completely into the
male end connector and tighten the four M3 set screws
firmly with the 1.5mm Allen wrench.
1.5MM ALLEN WRENCH
M3 SET SCREW
MALE END CONNECTOR
POWER FEED CABLE
8
5
6
C
2
D
MONORAIL FEED CONTACT
SURFACE TRANSFORMER
9
MALE END SIDE
9: Push the male end connector completely into the Monorail
surface mount transformer feed contact.
NOTE:
transformer, MT-600-12-_ models require two Monorail adjustable
power feed, one for each feed contact.
The 12 volt 600 watt, dual feed Monorail surface mount