Edge Lighting Out-Riggers - Manual (Page 3)

15: Push the straight conductive connectors into the canopy
end connector.
16: Push the out rigger arm entirely onto the straight
conductive connectors, and hold it in place.
H
CANOPY END
CONNECTOR
STRAIGHT CONDUCTIVE
CONNECTOR
15
17: While holding the out rigger arm in place, feed the aircraft
cable through the cable grip by pushing the tab down.
18: Pull the aircraft cable out through the hole on the cable
grip. Adjust the out rigger arm so that it is perpendicular to
the wall, release the tab to lock the out rigger arm in place.
19: Trim off the excess aircraft cable coming out of the cable
grip.
AIRCRAFT CABLE
TAB
OUT RIGGER ARM
CABLE GRIP
14: Feed the aircraft cable through the cable post and screw
the cable post completely onto the integrated
washer-nipple.
G
AIRCRAFT CABLE
CABLE POST
INTEGRATED
WASHER-NIPPLE
14
I
OUT RIGGER ARM
STRAIGHT
CONDUCTIVE
CONNECTOR
16
16 J
3
17
18