Edge Lighting Straight Rail - Manual (Page 2)

2
Wiremold Pipe Bender
(Horizontal or Vertical Bend)
D
PEDAL
MONORAIL
HOOK
NOTE: The Wiremold pipe bender can be used to create smooth
horizontal curve of 90 ° or less. Do not step on the pedal of the
pipe bender which will flatten and damage the Monorail. For
offsets, refer to the instructions provided with the pipe bender.
1: Feed the Monorail through the pipe bender hook.
2: Start bending the Monorail with small angles (less than 10 °)
by gently pulling back on the pipe bender handle.
3: After each bend unhook and check the Monorail against the
pattern.
Free Style Horizontal Bending
C
1
CENTER OF THE
BENDING POINT
PUSH PUSH
2 2
1: Locate the center of the bending point on a Monorail section.
The bending point should be centered between hands.
2: For a smooth curve, bend the Monorail with hands as far
apart as possible. Move hands close together as bending
progresses and the desired shape is achieved.
1
2
Joining Monorail Sections with
Straight Isolating Connectors
F
1/16 ALLEN
WRENCH
#6-32 SET SCREW
STRAIGHT ISOLATING
CONNECTOR
1: Push the straight isolating connectors completely into one
Monorail section end and push the other Monorail section
entirely onto the straight isolating connectors.
2: Tighten the #6-32 set screws on each of the isolating
connector firmly with the 1/16 Allen wrench. Do not over
tighten the set screws as this may strip the threads.
1
2
Joining Monorail Sections with
Straight Conductive Connectors
E
STRAIGHT
CONDUCTIVE
CONNECTOR
1: Push the straight conductive connectors completely into the
end of one Monorail section.
2: Push the other Monorail section entirely onto the straight
conductive connectors.
2
1