Edge Lighting Sloped Ceiling Surface Mount Magnetic Transformers - Manual (Page 3)

3
10: Connect the white transformer wire to the white extension
wire with a wire nut.
11: Connect the black transformer wire to the black extension
wire with a wire nut.
F
H
2MM ALLEN
WRENCH
13
M4 BUTTON
HEAD SCREW
13: Place the transformer cover onto the transformer housing.
Replace and tighten the five M4 button head screws with
the 2mm Allen wrench.
HOUSING
COVER
13
13
11 10
12: Hook one of the transformer cover screw holes next to the
rectangle cutout, onto the Monorail feed contact set screw.
G
MONORAIL FEED
CONTACT SET SCREW
COVER
12
Install the Monorail to the
Transformer
I
NOTE:
support the Monorail while connecting Monorail to the surface
mount transformer (refer to the instructions provided with the
sloped standoffs).
The proper size sloped standoffs should be installed to
1: Unscrew the cap from the power housing.
2: Slightly loosen the 3/8-24 set screw on the cap with the
3/16 Allen wrench provided, (DO NOT REMOVE IT).
3/16 ALLEN WRENCH
POWER HOUSING
3/8-24 SET SCREW
CAP
2
1
3
3: Place a Monorail section into the standoff and power
housings.
4: While supporting the Monorail section, screw (Do Not
Tighten Completely) the standoff housing to the standoff
housing nipples to support the Monorail section (refer to the
instructions provided with the standoff).
5: Screw (Do Not Tighten Completely) the caps to the
power housings to hold the Monorail section.
6: Slide the Monorail section so that the end slightly passes
through both power housings.
7: Insert the provided isolating connectors into that end of the
Monorail section. Make sure that the set screws on the
isolating connectors are visible.
ONE MONORAIL SECTION
3
J
ISOLATING
CONNECTOR
6
7
#6-32 SET
SCREW
5
STANDOFF
HOUSING
NIPPLE
6