Edge Lighting 2 Circuit Feed-End Power Feed Canopies - Manual (Page 2)

2
2
#8-32
SCREW
D
3/32 ALLEN
WRENCH
4
5: Place all wires inside the electrical box.
6: Secure the power feed canopy to the electrical box by
tightening the two provided #8-32 screws with the 3/32
Allen wrench.
COM
HOT 2
HOT 1
Install the Canopy
C
BOTTOM END
CONNECTOR
TOP END
CONNECTOR
HOT 2
COM
HOT 1
MIDDLE END
CONNECTOR
1: Turn the power to electrical box off.
2: Connect the wire that is attached to the bottom end
connector to the low voltage wire marked "COM" with a wire
nut.
3: Connect the wire that is attached to the middle end
connector to the low voltage wire marked "HOT 2" with a
wire nut.
4: Connect the wire that is attached to the top end connector
to the low voltage wire marked "HOT 1" with a wire nut.
NOTE: Use the universal round crossbar (provided) if the electrical
box holes are not spaced 2-3/4" apart.
NOTE: The low voltage wires should be present in the electrical
box. Refer to the instructions provided with the remote
transformer to install the transformer and the low voltage wires
before proceeding with the steps below.
3
2
6
5
Install the Monorail 2 Circuit to
Power Feed Canopy
E
CANOPY END
CONNECTOR
STRAIGHT
CONDUCTIVE
CONNECTOR
1
1: Push the straight conductive connectors into the canopy end
connector.
F
CANOPY END
CONNECTOR
STRAIGHT CONDUCTIVE
CONNECTOR
MONORAIL 2 CIRCUIT
2: Push a Monorail 2 Circuit section entirely onto the straight
conductive connectors. Make sure that Monorail 2
Circuit section is supported by Monorail 2 Circuit
standoffs.
2