Edge Lighting 2 Circuit 4" Power Feed Canopies User Manual
Page 2
2
7: Unscrew the cap from the power housing.
8: Slightly loosen the 3/8-24 set screw on the cap with the
3/16 Allen wrench provided, DO NOT REMOVE IT.
9: Slightly loosen the knurled nut on the power housing so that
the middle contact moves back and clears the power housing
opening.
C
CAP
3/8-24 SETSCREW
POWER HOUSING
Install the Monorail 2 Circuit to the Power Feed Canopy
7
MIDDLE
CONTACT
KNURLED
NUT
9
D
CAP
POWER HOUSING
MONORAIL 2 CIRCUIT
10: Place the a section of Monorail 2 Circuit into the power
housing. Make sure that the Monorail 2 Circuit is supported
by the standoffs. Refer to the instructions provided with the
standoffs.
11: Tighten the cap to the power housing. Make sure the
cap is not cross threaded.
E
CAP
10
11
12: Tighten the 3/8-24 set screw on the cap with the 3/16
Allen wrench for proper power connection.
13: Tighten the knurled nut for proper power connection.
HOT 1
HOT 2
CAM
13
KNURLED NUT
3/8-24 SET SCREW
3/16 ALLEN WRENCH
8
12