Edge Lighting 2 Circuit Sloped Ceiling Power Feed Canopies User Manual
Page 2
CAP
3/8-24 SETSCREW
POWER HOUSING
1
2
MIDDLE
CONTACT
KNURLED
NUT
3
2
1: Unscrew the cap from the power housing.
2: Slightly loosen the 3/8-24 set screw on the cap with the
3/16 Allen wrench provided, (DO NOT REMOVE IT).
3: Slightly loosen the knurled nut on the power housing so that
the middle contact moves back and clears the power housing
opening.
C
Install the Monorail 2 Circuit to the Power Feed Canopy
D
CAP
POWER HOUSING
MONORAIL 2 CIRCUIT
4: Place the a section of Monorail 2 Circuit into the power
housing. Make sure that the Monorail 2 Circuit is supported
by the sloped standoffs. Refer to the instructions provided
with the
standoffs.
5: Tighten the cap to the power housing. Make sure the
cap is not cross threaded.
sloped
E
CAP
4
5
6: Tighten the 3/8-24 set screw on the cap with the 3/16
Allen wrench for proper power connection.
7: Tighten the knurled nut for proper power connection.
HOT 1
HOT 2
CAM
7
KNURLED NUT
3/8-24 SET SCREW
3/16 ALLEN WRENCH
6