Edge Lighting Fast Jack Multi-Port Canopies - Manual

SAVE THESE INSTRUCTIONS!
FJP-26RE-2-_
- This product is ETL listed for indoor dry locations.
- This product is dimmable with a standard incandescent
dimmer.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
A
1: Loosen and remove the six Phillips screws from the canopy
to remove the mounting plate.
Installation Instructions for 26" Rectangle 2 Port Fast Jack Canopy
Install the Canopy
1
904-FJP-26RE-2-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
PHILLIPS SCREW
1 1
MOUNTING PLATE
CANOPY
© 2009 Edge Lighting. All Rights Reserved.
1
B
2 Align the mounting plate holes with the electrical box holes
and mark a point through the mounting plate holes onto the
ceiling. These points are used for the anchors. :
MOUNTING PLATE
ELECTRICAL BOX HOLE
2 2
C
3 4
ANCHOR
3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
D
#8-32 SCREW
CROSSBAR ASSEMBLY
5:
center hole.
6: Mount the crossbar assembly to the electrical box holes with
the provided #8-32 screws.
Feed the power wires through the crossbar assembly
5
6
6