Edge Lighting 150W/12V Surface Mount Magnetic Transformer - Manual (Page 4)

4
Install the Monorail to the Transformer
I
POWER HOUSING
3/8-24 SET SCREW
NOTE:
the Monorail while connecting Monorail to the surface mount
transformer (refer to the instructions provided with the standoffs).
The proper size standoffs should be installed to support
1: Unscrew the cap from the power housing.
2: Slightly loosen the 3/8-24 set screw on the cap with the
3/16 Allen wrench provided, DO NOT REMOVE IT.
P1
3/16 ALLEN WRENCH
CAP
J
P1
3: Place the Monorail into the power housing and support it
with the standoffs (refer to the instructions provided with
the standoffs).
4: Tighten the cap to the power housing. Make sure the cap
is not cross threaded.
5: Tighten the 3/8-24 set screw with the 3/16 Allen wrench
provided on the cap firmly for proper power connection. P1
POWER HOUSING
3/8-24 SET SCREW
3/16 ALLEN WRENCH
CAP
MONORAIL
1
2
3
3
3
4
5
K
MONORAIL FEED
CONTACT
PLASTIC
INSERT
6
6: Plug the Monorail feed contacts with the provided plastic
inserts.