Edge Lighting 600W/12V Dual Feed Surface Mount Magnetic Transformer - Manual (Page 4)

4
Install the Monorails to the Transformer
I
STRAIGHT
CONDUCTIVE
CONNECTOR
1
ONE MONORAIL SECTION
MONORAIL FEED CONTACT
SURFACE TRANSFORMER
3
2
MONORAIL
SECTION
NOTE:
connecting the Monorail to the transformer (refer to the
instructions provided with the Monorail 1" standoffs).
The Monorail 1" standoffs should be installed before
1: Push one end of the straight conductive connectors
(provided with the transformer) completely into one end of
the Monorail section.
2: Push the end of the straight conductive connectors (along
with the Monorail) completely into one Monorail feed
contact. While supporting the Monorail section by hand
connect this section to the Monorail 1" standoffs (refer to the
instructions provided with the Monorail 1" standoffs).
3: Repeat steps 1 & 2 for the second Monorail section.
SECOND MONORAIL
SECTION
NOTE:
together. Load each Monorail section to Maximum 300 watt.
The two Monorail feed contacts are not connected