Edge Lighting 2x250W/12V Surface Mount Magnetic Transformer - Manual (Page 4)

4
Install the Monorail 2 Circuit Sections to the Transformer
I
STRAIGHT
CONDUCTIVE
CONNECTOR
1
ONE MONORAIL 2 CIRCUIT SECTION
MONORAIL 2 CIRCUIT
FEED CONTACT
SURFACE
TRANSFORMER
3
2
MONORAIL
SECTION
2
CIRCUIT
NOTE:
before connecting the Monorail 2 Circuit to the transformer (refer
to the instructions provided with the Monorail 2 Circuit 1"
standoffs).
The Monorail 2 Circuit 1" standoffs should be installed
SECOND MONORAIL
SECTION 2 CIRCUIT
NOTE:
connected together.
The two Monorail 2 Circuit feed contacts are not
1: Push one end of the straight conductive connectors
(provided with the transformer) completely into one end of
the Monorail 2 Circuit section.
Monorail 2 Circuit Monorail 2
Circuit While supporting the Monorail 2
Circuit section by hand connect this section to the Monorail 2
Circuit 1" standoffs (refer to the instructions provided with
the Monorai 2 Circuitl 1" standoffs).
Monorail 2 Circuit
2: Push the end of the straight conductive connectors (along
with the
) completely into one
feed contact.
3: Repeat steps 1 & 2 for the second section.
SWITCH 1
J
SWITCH 2
HOT 1
HOT 2
COM
HOT 2
HOT 1
COM
NOTE:
Switch 2 turns on/off circuit 2 (COM & HOT 2). Load each circuit of
Monorail 2 Circuit to MAXIMUM 250 watt.
Switch 1 turns on/off the circuit 1 (COM & HOT 1) and
4: If using only one Monorail 2 Circuit section then plug the
unused Monorail 2 Circuit feed contact with the plastic insert
provided
K
MONORAIL FEED
CONTACT
PLASTIC
INSERT
4