Edge Lighting 12" Fast Jack Canopies Without Transformers - Manual (Page 2)

E
ELECTRICAL BOX
CANOPY
6: Place all the wires and wire nut connections inside the
canopy.
7: Align and secure the canopy to the mounting plate by
tightening the three #8-32 screws.
8:
the Fast Jack canopy connector. Use fingers to tighten the Fast Jack fixture connector into
CAUTION: Risk of Fire:
canopy ports should not exceed the remote transformer rated
capacity.
The total load of the Fast Jack
FAST JACK
FIXTURE
CONNECTOR
2
D
4: Make sure that the mounting plate is grounded in
accordance with local electrical codes.
5: Connect each canopy wire to one low voltage transformer
wire with a wire nut.
5
5
#8-32
SCREWS
7 7
F
8
8
FAST JACK
CANOPY
CONNECTOR
8
6