Edge Lighting Fast Jack Multi-Port Canopies Without Transformers User Manual
Page 2
2
E
#8-32 SCREW
CROSSBAR ASSEMBLY
5: Feed the power wires through the crossbar assembly
center hole.
6: Mount the crossbar assembly to the electrical box holes with
the provided #8-32 screws.
5
6
6
F
MOUNTING PLATE
NUT
POWER WIRE
COVER
ELECTRICAL BOX
7
7:
crossbar threaded nipple and secure it with the nut provided.
Slide the cover and mounting plate center hole onto the
8:
#8 screws.
Secure the mounting plate to the anchors with the provided
G
8
8
#8 SCREW
H
9: Make sure that the mounting plate is grounded in
accordance with local electrical codes.
10: Connect each canopy wire to one low voltage transformer
wire with a wire nut.
CANOPY
ELECTRICAL BOX
9
10
10
#8-32 SCREW
11: Place all the wires and wire nut connections inside the
canopy.
12: Align and secure the canopy to the mounting plate by
tightening the six #8-32 screws.
11
12
12
I
FAST JACK
FIXTURE
CONNECTOR
J
13
FAST JACK
CANOPY
PORT
13
13:
one Fast Jack canopy port.
Use fingers to tighten each Fast Jack fixture connector into
CAUTION: Risk of Fire:
The total load of the Fast Jack
canopy ports should not exceed the remote transformer rated
capacity.