Edge Lighting Cirrus Channel Suspension, Direct 1" Lens - Manual

SAVE THESE INSTRUCTIONS!
- This product is suitable for indoor locations.
- This instruction shows a typical installation.
IMPORTANT INFORMATION
Installation Instructions for Cirrus Channel Suspension D1
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2014 Edge Lighting. All Rights Reserved.
1
904-CCS-D1-06
CCS-D1-_
JOINER BRACKET
CHANNEL
1
LENS
1: Lift a section of the lens at the end of the channels where
the connectors are visible. Slide the channel over the joiner
bracket and ensure the male & female connectors mate
properly.
2: Push the lens back into the channel.
NOTE: Omit this section if the channel is made out of a single
piece.
NOTE: Prior to installation, multi-sectional Cirrus Channel should
be connected together for marking proper measurements.
NOTE: It is recommended more than one person to assist in this
installation.
Connecting Channel Sections
JOINER CHANNEL
MALE
CONNECTOR
FEMALE
CONNECTOR
CHANNEL
FRONT
VIEW
TOP OF CHANNEL
A
NOTE: When using Edge Lighting Slim Profile Junction Box
(C-1RE-BOX), continue to "Install the Channel using the Junction
Box (C-1RE-JBOX)" on page 3.
CHANNEL CHANNEL
JOINER BRACKET
BACK
VIEW
3: Position the joiner bracket where the two channels meet.
Tighten four #6-32 set screws using the 1/16 Allen wrench. 1/16 ALLEN
WRENCH
#6-32 SET
SCREW
3
Adjusting Cable Position
1: Loosen (DO NOT REMOVE) the #4-40 set screw on the
sliding post bushing and bed with a 0.05" Allen wrench.
2: Slide the strain relief tube out of the sliding post using a pair
of needle-nose pliers.
WARNING: To avoid damaging the coaxial cable electrical
connection, make sure that the end of the coaxial cable coming
out of the fixture is held with thumb before relocating sliding
posts.
COAXIAL CABLE
STRAIN RELIEF
SLIDING POST
#4-40 SET SCREW
0.05" ALLEN WRENCH
C
HOLD CABLE HERE
1
2
1
#4-40 SET SCREW
CHANNEL
B